9:00 am - 9:15 am

Welcome

9:15 am - 10:00 am

imc

Measurement and control systems for use in test bench environments

10:00 am - 11:00 am

Categories and Examples

• Development test benches for small motors and eDrive engines
• Endurance test stand for life time verification
• End-of-Line / production line test riggs
  • manual or fully automated motor transportation

11:00 am - 11:15 am

Coffee Break

11:15 am - 12:15 pm

Design Engineering

• Structure, setup and components for electrical motor test benches
• Safety issues

12:15 pm - 1:15 pm

Lunch break – You’re invited

1:15 pm - 2:00 pm

Sensors

• Measuring mechanical, electrical and noise phenomena
• Calibration

2:00 pm - 2:45 pm

Software Part 1

• imc OMEGA
  • Control software for test benches
  • parameterization of test procedures
  • test run
• Standardized test procedures
  • for active and passive measurement of electrical engines; e.g.:
    • cogging torque
    • back EMF
    • static or dynamic performance
    • torque ripple
    • drag torque
    • phase resistance and inductance
    • static and dynamic flux distribution

2:45 pm - 3:00 pm

Coffee Break

Software Part 2

• imc FAMOS:
  • Analytics of measurement data
  • result calculation and report generation
• imc WORLD

3:45 pm - 4:00 pm

Closing Remarks